Thingiverse
Cap for Tupperware rolling pin
door Lars1976
5
Downloads
1
Likes
0
Makes
Cap for rolling pin which can be filled with water. Pretty sure it's Tupperware.
Print gasket in tpu, or reuse an existing one. I used 0.2 layer height. Bottom layer concentric and then three layer with lines. Enable ironing on top layer. Should be pretty watertight.
Print gasket in tpu, or reuse an existing one. I used 0.2 layer height. Bottom layer concentric and then three layer with lines. Enable ironing on top layer. Should be pretty watertight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!