Thingiverse
Capacitive 18mm sensor adjustable
door Gamu_Zgz
0
Downloads
1
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://v1.tinkercad.com/things/1P3EKniRi1T
It's inspired in https://www.thingiverse.com/thing:2153030 Right Side 18mm Sensor Anet A8 Stock.
I find difficult to fine adjusting z end so i started from scratch magink gapes to lmove uo por down the whole mount.. I alsa move a litle to the right the holder so i can adjust the nut much better . WHen i try it i'll put the changest to make to the marlin firmware to adjust it.
Still working on it.
It's inspired in https://www.thingiverse.com/thing:2153030 Right Side 18mm Sensor Anet A8 Stock.
I find difficult to fine adjusting z end so i started from scratch magink gapes to lmove uo por down the whole mount.. I alsa move a litle to the right the holder so i can adjust the nut much better . WHen i try it i'll put the changest to make to the marlin firmware to adjust it.
Still working on it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!