MakerWorld
Electronics
Ver Modelo
Capacitive Mositure Sensor ESP32
99
Descargas
65
Likes
59
Makes
Created an enclosure for a capacitive moisture sensor and ESP32-C3 Mini. The fit is snug. The sensor orientation must match the one shown in the pictures due to a collision with components on one side. The connector, without cables, fits inside the case, encouraging direct soldering of cables instead of using the connector. The F3D file is included for further modifications or adjustments, as every Chinese board can vary slightly in design.If you decide to leave the original connector in place, it is strongly advised to use electrical tape to cover its pins!!!The connection should look something like this Boost MeBecause sometimes we all need a little boost—no coffee required.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
