Thingiverse
Capacitor Holder
von Rexxenexx
4
Downloads
2
Likes
0
Makes
The Capacitor Holder can be used in any situation where you need to mount/test a 5mm pitch capacitor. The capacitor can be mounted vertically or horizontally. Requires two spade terminals for connection.
To get tight tolerances please follow the print settings. At a minimum print at 0.1mm Resolution,
To install:
1. Cut the capacitor leads so that they are 10mm long.
2. Insert the spade terminals into the holder. Note which side is the negative terminal.
3. Insert the capacitor either on top or in the socket on the side with the marked negative lead in the proper orientation.
Done!
If you find this 3D Print fun or useful and want to support the artist, click the "Tip Designer" button! Thank You.
To get tight tolerances please follow the print settings. At a minimum print at 0.1mm Resolution,
To install:
1. Cut the capacitor leads so that they are 10mm long.
2. Insert the spade terminals into the holder. Note which side is the negative terminal.
3. Insert the capacitor either on top or in the socket on the side with the marked negative lead in the proper orientation.
Done!
If you find this 3D Print fun or useful and want to support the artist, click the "Tip Designer" button! Thank You.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
