Slicer Discord
Cape May Insert – 3D printable model from Thingiverse Thingiverse

Cape May Insert

by Patella
21 Downloads
11 Likes
1 Makes
Go to Model
Cape May Insert. Holds sleeved cards. (It should hold just about any sleeves you throw at it. (I had some super-thick Titan Shields for the large cards, and it holds those, so...) This doesn't work so well as a table organizer, just because it took a little work to get all those minis organized.

A few notes:
* I know that the Landmark Bases are not player specific pieces. They just happen to fit 5 to a player tray, so that's where they went. Obviously share them out as needed during play.
* In the same area as the Landmark Bases, I placed the Prestige Tokens. You can't really see them in any photos and I figured folks might ask.
*The Token spaces in the Victorian Minis tray are NOT the same size. Cottage Tokens go in the two left-most spaces and Shop Tokens go in the two right-most. Make certain the Shop tokens go in with a flat side up/down and "points" to the left/right.
* The Player Markers are a little tight in their area. (That's also where I put the Income Tokens
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection