Thingiverse
Captain America Shield
von Millhouse_5
1.4k
Downloads
1.1k
Likes
10
Makes
All pieces sliced to fit on the CR-10.
Inner and middle rings to be printed standing up while the outer ring can sit level on the bed
Assemble each individual ring and then put the shield together. The tolerances will be tight so don't use too much glue.
Edit: Added 1/8 segment middle and outer rings to accommodate for smaller printers.
Inner and middle rings to be printed standing up while the outer ring can sit level on the bed
Assemble each individual ring and then put the shield together. The tolerances will be tight so don't use too much glue.
Edit: Added 1/8 segment middle and outer rings to accommodate for smaller printers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
