Thingiverse
Models
Zum Modell
Captain Marvel Helmet
654
Downloads
575
Likes
2
Makes
This was modelled based off of references from posters, and the Hot Toys prototype photos.
The helmet was originally going to be used as part of a bust, however I couldn't figure out a good way of modelling the hair so I thought I may as well hollow it out and turn it into a helmet :)
The width of the inside of the helmet (ear to ear) is around 150mm, so the scaling may require a little tweaking to get a good fit.
The helmet was originally going to be used as part of a bust, however I couldn't figure out a good way of modelling the hair so I thought I may as well hollow it out and turn it into a helmet :)
The width of the inside of the helmet (ear to ear) is around 150mm, so the scaling may require a little tweaking to get a good fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
