Captain's Wheel Spinner

**Uses 1 608ZZ Bearing. [Order from Amazon](http://amzn.to/2jZNTVo)**

Used OpenSCAD to design a captains wheel spinner.

For printing you'll want to take into account the dimensional accuracy as you want the bearings to be a tight fit. Scaling the model should help adjust to get a good fit, if it's a little loose you can use a bit of CA glue (superglue) to fix it in position. _Note: Be careful not to get any glue on the bearing as you could seize it up._

Be sure to share any comments and photos if you print one!