Captive Customizable Supported Cable Holder

I loved the original remix cable holder, but found the arms of the holder, which need to apply pressure to the desk, often snapping over time.

I made a simple modification to hopefully increase the strength of arms. So far it seems better.

Note: To customize this for any desk, do as follows:

Measure the width of the desk in mm

Multiply the width by 1.872 (e.g. 35mm * 1.872 = 65.52mm)

That number is the needed x-length of the model for your desk. Most slicers should be able to scale along the axis to reach it. You can also scale uniformly, but it will be considerably larger and the wire hole may be loose.