Thingiverse
Captured Bolt
por flashboiler
1
Descargas
2
Likes
0
Makes
My take of the old captured bolt. 1mm and 1_5mm refer to the gap between the bolt and nut. On my Prusa the 1mm was a bit hard to turn at 1st and the 1_5 is just a bit sloppy but acceptable.
Printed with the bolt standing up, the nut near the bottom. Use "Support on build plate only" (PrusaSlicer) or eq. I used .3mm layer height with PLA.
Enjoy!
Printed with the bolt standing up, the nut near the bottom. Use "Support on build plate only" (PrusaSlicer) or eq. I used .3mm layer height with PLA.
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!