Thingiverse
Car Retaining Clip Set
door EJCWolverine
2
Downloads
4
Likes
0
Makes
I printed a few retaining clips from this website and not one of them held up. I even printed at 100% infill. I used PLA because that's the filament of my choice.
This is for my 2007 Rav4's engine (undercarriage) splash guard.
I hope this works for you.... :\
This is for my 2007 Rav4's engine (undercarriage) splash guard.
I hope this works for you.... :\
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!