Thingiverse
Car USB Cables Holder
por DonJuanito
50
Descargas
28
Likes
0
Makes
My nephew replaced his original (dumb) Suzuki Swift car audio system by an Android one (https://www.aliexpress.com/item/4000270216492.html). The new systems has two USB connectors where the original one had only a single one. So, I designed this holder for two female USB connector cables.
The Android system comes with two USB cables with female connectors.
For assembly, use either two small countersunk screws or insert small sections of 1.75mm filament in the 3 provided channels and melt their ends.
The original USB connector hole was too small for this dual connector housing, so it had to be enlarged with a stepped drill bit. In this particular case, the enlargement had to be done in the upper right direction only as some space is needed for the assembly nut.
As usual, the OpenSCAD source file is heavily commented so it should be easy to adapt it to a different set of cables.
As a warning to anyone wishing to use this Android system in their Suzuki Swift, we had to cutout
The Android system comes with two USB cables with female connectors.
For assembly, use either two small countersunk screws or insert small sections of 1.75mm filament in the 3 provided channels and melt their ends.
The original USB connector hole was too small for this dual connector housing, so it had to be enlarged with a stepped drill bit. In this particular case, the enlargement had to be done in the upper right direction only as some space is needed for the assembly nut.
As usual, the OpenSCAD source file is heavily commented so it should be easy to adapt it to a different set of cables.
As a warning to anyone wishing to use this Android system in their Suzuki Swift, we had to cutout
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
