Slicer Discord
Car Wars 6E Storage Boxes – 3D-Druckmodell von Thingiverse Thingiverse

Car Wars 6E Storage Boxes

von rjneves
11 Downloads
9 Likes
0 Makes
Zum Modell
This is my attempt at making all the Cars that came with the Car Wars 6E Double Ace award set fit into one of the Car Wars Minis boxes for easier storage and transportation. There are 5 different sizes that will accommodate all the different size cars currently released.

The sizes are:

- Type A - 80x42x26mm
- Type B - 80x49x26mm
- Type C - 80x49x39mm
- Type D - 74x42x39mm
- Type E - 80x42x39mm

The 26mm boxes can be stacked in the Minis box for two levels.

Each box has a notch and a recess on each side so you can use either the clips (included) or a magnet (5mm round x 1mm) to "connect" the boxes. They are also chamfered on the top and bottom so boxes of the same width and length can be stacked.

To fit them all in the box this is how I arranged them:

C - C - B - A - A
C - C - B - A - A
D - D - D - D - D - D
E - E - E

The BAA section is layered with two layers and the E boxes are sideways. Please refer to the picture of the full set. This will fit 25 cars
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
80 mm (Mittel)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen