Thingiverse
Card dispencer
door nowwnik
1
Downloads
4
Likes
0
Makes
Parametric card dispenser for board games
Some of the popular card sizes are attached to the project, but you can also change the dispenser sizes in fusion 360 in the change parameters section.
Please do not delete the added values to your dimensions. these parameters have been adjusted for ease of use.
the constructive lifting angle of the cards is 5-7 degrees, depending on the parameters
Some of the popular card sizes are attached to the project, but you can also change the dispenser sizes in fusion 360 in the change parameters section.
Please do not delete the added values to your dimensions. these parameters have been adjusted for ease of use.
the constructive lifting angle of the cards is 5-7 degrees, depending on the parameters
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
