Thingiverse
Card Holder Wallet
von Chiikusu
0
Downloads
0
Likes
0
Makes
Print 2x: 1x normal and 1x mirrored
Also you'll need a Rubberband with 20mm width and about 18cm long, to put around the two pieces.
Then just put the sides with the slope together and put the rubberband around it.
Also you'll need a Rubberband with 20mm width and about 18cm long, to put around the two pieces.
Then just put the sides with the slope together and put the rubberband around it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
