Thingiverse
Card Holders
door Azrael60409
1
Downloads
1
Likes
0
Makes
Two card holders of similar style. One with a highback, one with a 'level' back.
This card holder fits a standard credit card.
I use it to hold all the spare membership cards, reward cards and VIP ards.
I have built a little divider between the two sections. On the back, Ive recessed holes for 'magnets. Its a pretty tight fit, and you will have to use a little CA glue or 5 minute epoxy.
I used rare earth magnets and have this stuck on the side of my fridge.
This card holder fits a standard credit card.
I use it to hold all the spare membership cards, reward cards and VIP ards.
I have built a little divider between the two sections. On the back, Ive recessed holes for 'magnets. Its a pretty tight fit, and you will have to use a little CA glue or 5 minute epoxy.
I used rare earth magnets and have this stuck on the side of my fridge.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!