Carrera digtal - Stackable Lego compatible bridgepier

This is a stackable Lego compatible bridge Pier thats meant to go under the Lanes of a carrrera digital 1/32. For the Lego bricks to fit (in my case because i had a little elephant foot) you need to nearly melt the Printed ,,Bricks'' on the side of the Part. Then press a 2x4 Stone in it to make the fit perfect. Under the Lanes there is a cross wich i have modeled a negativ of into the Part. From my knowledge curves, and straights have this cross on them.

Print settings:

Material: Anycubic PLA 220C nozzle 65C Bed
Layer Height: doesnt matter
Print speed: wouldnt go over 80mms
Support: you dont need it
Rafts: none
Build plate adhesion: none
Infill: 10%