Thingiverse
Carrera Track Accessory Pack
von blistik
206
Downloads
138
Likes
1
Makes
My collection of primarily my designs, plus the remixed track connector (for completeness), for the Carrera Slot Car Track System (Evolution/Digital 124, 132).
Note: Some of these parts are a works in progress and may need some more tweaking. This was a starting point and I decided to share as it may inspire others to give it a go. Enjoy!
update: added variant for guard rail holder as clip was too fragile with PLA
update: added Narrow variant for guard rail holder to fit 4/15 Corner pieces near joins
update: added 50mm custom guard rail holder. I cut barriers from PETG copolyester sheet.
update: added Carrera 1-3 Straight Track Border (dual colour)
Note: Some of these parts are a works in progress and may need some more tweaking. This was a starting point and I decided to share as it may inspire others to give it a go. Enjoy!
update: added variant for guard rail holder as clip was too fragile with PLA
update: added Narrow variant for guard rail holder to fit 4/15 Corner pieces near joins
update: added 50mm custom guard rail holder. I cut barriers from PETG copolyester sheet.
update: added Carrera 1-3 Straight Track Border (dual colour)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
