Carriage Ghost Flyingbear E3DV6

Good day. I present a printing carriage for the Ghost Flyingbear V3,4,4S printer, for an E3DV6 extruder and 4020 and 5015 airflow fans. BLtouch is designed.
The carriage bushings are made for LM8UU bearings with a diameter of 15 mm.
A fastener for belt tensioning has been mounted on the carriage (Screw M2.5 - Nut-Gasket).
Installed top cover for aesthetics))) and overall strength.
The E3DV6 extruder is mounted using a separate printed locking wedge, fixed on the back of the carriage with an M2.5 x 25 / screw (2.5 x 4 x 6 sleeve must be melted into the base of the BL touch mount)

ATTENTION!!!! This project is under development and there may be some flaws and errors in the original. It is best to print the carriage at 100% resolution by first printing a sleeve sample (STL ‘Bush-test’) to check the bearing fit. (After which you can increase the% scaling in the slicer). All comments and suggestions can be written in PM or by mail [email protected])


I also upload the original .f