Case for Circular Puzzle

This case is intended to be light, and easy to print. Most edges are filleted or chamfered. The bottom outside borders are slightly chamfered to ease the removal from bed and avoid the frecuent (and horrible) edge-brim-whatever. The flat part is 0.6 mm, dont worry, it's flexiblility helps to push-in or pull-out the two parts.

This was printed with an horrible quality PLA 7 years old (OMG) in an Artillery Sidewinder X2, slicer: Cura 5.6, and layers 0,2 (standard). Adaptative layers: ON, ironing: ON


NOTE: high polygon count, may be a bit slow to handle in some computers. But don't worry, extra soft lines.