Thingiverse
Case for Craftmade Fan Remote
by monkeybiziu
2
Downloads
1
Likes
0
Makes
A significantly slimmer case for a remote control used by Craftmade-brand fans and remote control systems.
Note - the case does require that you remove the large plastic overhangs on either end of the remote and clip the non-used exterior wires.
The case screws together with two M3 machine screws - tap the holes after printing.
Recommend setting support overhangs to 55 degrees - this will keep Cura from adding supports around the outside edges that aren't needed but keep them for the screw holes.
Note - the case does require that you remove the large plastic overhangs on either end of the remote and clip the non-used exterior wires.
The case screws together with two M3 machine screws - tap the holes after printing.
Recommend setting support overhangs to 55 degrees - this will keep Cura from adding supports around the outside edges that aren't needed but keep them for the screw holes.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!