Case for D300VS

These are the STLs for a case I printed for my D300 VS.

It has a few problems:
1) the front plexi-glass is too close to the print bed to allow my Titan Aero to come all the way to the front of the bed.
2) the PSU mount I printed doesn't leave adequate room for the wiring, so I haven't included it in the files
3) I haven't designed a handle to open the doors yet
4) the doors slide up in single sections, so it takes a lot of space vertically.
5) the door latching mechanism isn't great, you hold the panels up by tightening screws into them
6) the screw holes are a little snug
7) there isn't quite enough room for the corner brackets, so the bottom doesn't come together snuggly

I printed it in PETG. If I decide to redo it, I will print it in ABS, which will be easy now that I have a good case! The pieces are printed with the larger, flat sides down. It may be possible to print them vertically so that you can put more than on piece on the bed at a time. If I redo it, it will