Thingiverse
Case for ESP32 with external Antenna
by pm3dka
2
Downloads
0
Likes
0
Makes
This case is for use with 4x6cm pcb and esp32 with ipex connector on it.
The lid has an mounting point for a bme280 board with two screw holes and 6 pins.
You need two small round head self tapping screws (m2x5-6mm max) for it.
One IPEX to RP-SMA pigtail can also be mountet on the lid.
ESP32 has to sit on the bottom of the pcb. Otherwise more case height would be needed to keep a centered antenna.
Assemble the pigtail before the bme280 pcb.
The lid has an mounting point for a bme280 board with two screw holes and 6 pins.
You need two small round head self tapping screws (m2x5-6mm max) for it.
One IPEX to RP-SMA pigtail can also be mountet on the lid.
ESP32 has to sit on the bottom of the pcb. Otherwise more case height would be needed to keep a centered antenna.
Assemble the pigtail before the bme280 pcb.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!