Case For EZABL (V2) Board

I didn't particularly want to cut up my CR-10's wiring loom to connect the "direct wire" EZABL kit, and I also didn't want a chunky barrel connector sticking out of a dirty great hole in the case using the "Ez-Connect" version so I modified one to my liking.

This basically consisted of removing the screw terminals from a "direct wire" kit, replacing them with a pair of three-pin JSTs (removed the centre pin from the "power" JST to avoid accidentally plugging it into the wrong socket).

Wasn't happy with the OEM case design so I designed this replacement which has holes exactly the right size for the wiring to go in and nothing else.

Note that this was designed around an EZABL V2 board, I'm not sure if the dimensions changed for the V3, it's a VERY snug friction fit into the case, you might have to touch up the corners of the board with a file to get it to fit.

Note the lid is "directional" there's a groove on three sides, the short side without the groove goes towards the ca