Thingiverse
Case for GLAMOS Walker
door valintw
0
Downloads
0
Likes
0
Makes
I designed this for 3 main reasons :
1) The power button is easily accidentally activated while mapping (e.g. when the device is in your pocket ) with this case the button is recessed, so requires a more positive action to activate.
2) To add a loop to allow the Glamos Walker to be attached to a lanyard or belt-clip
3) To add some ruggedization to the the device and/or prevent damage if dropped etc.
Print in TPU with < 50% infill (this gives a more cushioning effect) orient bottom side on the plate (the side with most surface area) The overhangs on the top surface should print OK without support with good settings - It also helps if the ambient temperature is very cold when printing :-P
1) The power button is easily accidentally activated while mapping (e.g. when the device is in your pocket ) with this case the button is recessed, so requires a more positive action to activate.
2) To add a loop to allow the Glamos Walker to be attached to a lanyard or belt-clip
3) To add some ruggedization to the the device and/or prevent damage if dropped etc.
Print in TPU with < 50% infill (this gives a more cushioning effect) orient bottom side on the plate (the side with most surface area) The overhangs on the top surface should print OK without support with good settings - It also helps if the ambient temperature is very cold when printing :-P
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
