Case for Hawk - Open Source Xbox Live Communicator

Simple case for open source OG Xbox communicator. For assembly use two M2, 6mm long screws. Or I should say 2mm diameter screws. Hole in top case is for 1.75mm transparent filament which works like lightpipe for LED. Depends on you printer setting this hole may require to be widen. I used a craft knife to calibrate this hole. It should have tight fit with filament. Bottom case have button for a switch on PCB. Watch out for it when you remove support.
It printed fine on Anet ET4 Pro with 0.6 nozzle.