Thingiverse
Case for Holmes Hobbies Crawlmaster Mini programmer
by HumboldtEF
2
Downloads
2
Likes
0
Makes
This is a case for the Holmes Hobbies Crawlmaster Mini Programmer (seen here https://holmeshobbies.com/electronics-and-wiring/programmers/serial-programming-device.html )
This requires two M2 x 6 (8 may work too)
The slot for the JST is keyed and the slot for the ESC (servo) plug is labeled with a - + S
I've left space for the pins to stick through on the bottom of the board. The diode and resister should go on the top as there is much more space inside the case on the top side.
This is a re-upload, the original could only be be found with the link (not searched for)
This requires two M2 x 6 (8 may work too)
The slot for the JST is keyed and the slot for the ESC (servo) plug is labeled with a - + S
I've left space for the pins to stick through on the bottom of the board. The diode and resister should go on the top as there is much more space inside the case on the top side.
This is a re-upload, the original could only be be found with the link (not searched for)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
