Thingiverse
Case for Mictronics' CAN-USB interface
von schmidt001
0
Downloads
0
Likes
0
Makes
This a case for mictronics' CAN-USB interface, see for the electronics details.
The case consists of two parts, the lower part has a built-in carrier structure for the PCB and holes for M2 nuts.
The upper part has holes for the LEDs, a small rocker switch to the enable or disable the internal terminator and 4 M2 screws. The slot allows to route a flat cable from the 10pin header to the outside to connect to CAN.
The case consists of two parts, the lower part has a built-in carrier structure for the PCB and holes for M2 nuts.
The upper part has holes for the LEDs, a small rocker switch to the enable or disable the internal terminator and 4 M2 screws. The slot allows to route a flat cable from the 10pin header to the outside to connect to CAN.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!