Slicer Discord
Case for Raspberry pi 3  and NAVIO2 – 3D-printbaar model van Thingiverse Thingiverse

Case for Raspberry pi 3 and NAVIO2

8 Downloads
3 Likes
0 Makes
Model downloaden
This is not fancy, but it is a workable case for a Raspberry pi 3 + NAVIO 2 board.

For mounting, you can either use the 50mm X 58mm hole pattern of the Raspberry, or the 35mm X 35mm pattern on the `bottom of the box. I left enough opening for adequate airflow.

Use M2.5 X 10mm screws to hold the boards in place. The holes in the bottom have a nut pattern for M3 nuts.

I left a hole for access to the memory card.

Make certain that you also download the cover for this box.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie