Thingiverse
Case for SONOFF WiFi Switch Module
door LBussy
11
Downloads
9
Likes
0
Makes
This is a case for the SONOFF 5V/12V Inching/Self-Locking WiFi Switch Module such as this one on Amazon:
https://smile.amazon.com/gp/product/B077Z5B461
It features cutouts to access the wire terminals, a hole for the Micro-USB power, as well as buttons and light pipes for the LEDs.
The lid is provided with both break-away supports in the countersunk screw holes, and without. I had no issues breaking them out but your printer may vary. Likewise, I have included the buttons with a brim and without. The one with the brim is intended to be printed with the bottom layer in concentric rings to allow tear-off.
4 x m3 x 20mm Allen-head screws are required.
If you would like to modify this design, here is the source:
https://www.tinkercad.com/things/7Q2espHHhEL
03/09/22: Apparently I forgot to add the buttons, they have been uploaded.
https://smile.amazon.com/gp/product/B077Z5B461
It features cutouts to access the wire terminals, a hole for the Micro-USB power, as well as buttons and light pipes for the LEDs.
The lid is provided with both break-away supports in the countersunk screw holes, and without. I had no issues breaking them out but your printer may vary. Likewise, I have included the buttons with a brim and without. The one with the brim is intended to be printed with the bottom layer in concentric rings to allow tear-off.
4 x m3 x 20mm Allen-head screws are required.
If you would like to modify this design, here is the source:
https://www.tinkercad.com/things/7Q2espHHhEL
03/09/22: Apparently I forgot to add the buttons, they have been uploaded.
LBussy publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
