Case for the Tesla-Android project

This is a simple case for the [Tesla-Android project](https://tesla-android.gapinski.eu)
Use it or tweak it as you like.

Assembly (hard to describe - look at the pictures):
_
Optional: put the 4 little bases (V1_Feet_4x) in the holes on the lower side of the base (V1_Plate_Bottom)
I glue a little piece of felt under them so that nothing can scratch

01. Put the Wall (V1_Wall_Bottom_Inside) in the middle guidance of the base (V1_Plate_Bottom)

02. Insert the side walls (V1_Wall_Top_Outside) carefully through the slots on the side of the middle plate (V1_Plate_Middle) - insert both side walls mirrored to each other (look for the fan hole which needs to be over the big heatsink of the pi)

03. Connect 02 with 01; make sure that the upper nose from (V1_Wall_Bottom) fits in the slot of the middle plate.

04. if needed mount the fans on the side walls

05. mount the two raspberry's on the inside walls (V1_Wall_Top_Inside_x2) mirrored to each other

06. fit the inside wal