Thingiverse
Case for TLSmoother
von Kristian_Laholm
8
Downloads
3
Likes
0
Makes
A simple case for Bigtreetech Smoother V1.0.
The PCB is hold in place by friction on the 4 pegs.
Hole in the bottom of the case and some clearance around the PCB for airflow.
I'm a noob at 3d-printing and modeling but hope this can be useful for someone.
Printed at 0.2 mm layer height and 10% infill.
Print with bottom of case down on the printbed.
The PCB is hold in place by friction on the 4 pegs.
Hole in the bottom of the case and some clearance around the PCB for airflow.
I'm a noob at 3d-printing and modeling but hope this can be useful for someone.
Printed at 0.2 mm layer height and 10% infill.
Print with bottom of case down on the printbed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!