Thingiverse
Case Stand for Raspberry Pi + 7" LCD
door sgpdude
55
Downloads
40
Likes
0
Makes
Wanted a sturdy stand for this case that I liked: https://www.thingiverse.com/thing:1164446
The left and right pieces are mirrored copies of each other and connect to the LCD screen through the two case parts using M3x10 screws. I also added holes in the base (in a 30mm by 140mm pattern) for mounting if desired.
The stands tilt the display at a 60 degree angle and take less than an hour and half (at the settings I used) to print each.
There isn't much clearance for the micro USB power connector at the bottom. A regular connector will work but the wire has to bend almost at a right angle. I use a right angled USB connector so I don't have an issue.
Just added a taller version to provide more clearance for the USB connector - it's the one with v7 in the filename.
The left and right pieces are mirrored copies of each other and connect to the LCD screen through the two case parts using M3x10 screws. I also added holes in the base (in a 30mm by 140mm pattern) for mounting if desired.
The stands tilt the display at a 60 degree angle and take less than an hour and half (at the settings I used) to print each.
There isn't much clearance for the micro USB power connector at the bottom. A regular connector will work but the wire has to bend almost at a right angle. I use a right angled USB connector so I don't have an issue.
Just added a taller version to provide more clearance for the USB connector - it's the one with v7 in the filename.
sgpdude publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
