Thingiverse
Case with 4040 Mount for Raspberry Pi Zero
von AllPro3D
72
Downloads
39
Likes
1
Makes
Hello Makers!
I am running Klipper on my "Ender 3 V2 Competition" with several sensors, endstops, etc. hooked up to the Raspberry Pi Zero W GPIO pins. Looking around, I couldn't find a case that would:
1) Cleanly bolt to the 4040 extrusions
2) Properly fix the pi in place without need for additional screws
3) Provide a clean cable route for GPIO-attached cables
I therefore went ahead and designed my own case from scratch. For the looks, I based it loosely on the case designed by guppyk.
Now, to mount the case follow these steps (check pictures also):
1) Insert two M3x6 hex screws in the corresponding holes of the case and loosely screw M3 t-nuts on those
2) Slide the case onto the 4040 extrusion of your choice and tighten them (make sure the t-nuts are oriented perpendicular to the extrusion).
3) Place the Pi Zero in the case as shown in the pictures and lead any cables out of the case through the corresponding slot.
4) Fix the Pi Zero in the case by pressing the SD Car
I am running Klipper on my "Ender 3 V2 Competition" with several sensors, endstops, etc. hooked up to the Raspberry Pi Zero W GPIO pins. Looking around, I couldn't find a case that would:
1) Cleanly bolt to the 4040 extrusions
2) Properly fix the pi in place without need for additional screws
3) Provide a clean cable route for GPIO-attached cables
I therefore went ahead and designed my own case from scratch. For the looks, I based it loosely on the case designed by guppyk.
Now, to mount the case follow these steps (check pictures also):
1) Insert two M3x6 hex screws in the corresponding holes of the case and loosely screw M3 t-nuts on those
2) Slide the case onto the 4040 extrusion of your choice and tighten them (make sure the t-nuts are oriented perpendicular to the extrusion).
3) Place the Pi Zero in the case as shown in the pictures and lead any cables out of the case through the corresponding slot.
4) Fix the Pi Zero in the case by pressing the SD Car
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
