Thingiverse
Cassette Shelving System
door fardog
15
Downloads
10
Likes
0
Makes
A shelving system for cassettes. I wasn't able to find anything that fit my shelf without wasting considerable space. With these files, you can build a shelf to whatever size you need.
The prints as uploaded are designed to fit on my Prusa i3 MK3S, and use 3/8" threaded rods, but you can customize it yourself: the fully parametric designs are available for Fusion 360 [here](https://a360.co/3ckwvmA). Just change the parameters used and make them any size, number of cassettes, etc. that you need.
This is designed to be pressure fit in a shelf, you can see from the photo above I have cut my 3/8" threaded rods to size and put them together with a connector, which can be expanded to fit into place. I applied some rubber pads to the feet to avoid them slipping about after being fit.
This could use a few adjustments, the feet get a bit in the way of the cassettes on the edge. In my case I just put cassettes that are in non-standard jewel cases at the edges.
The prints as uploaded are designed to fit on my Prusa i3 MK3S, and use 3/8" threaded rods, but you can customize it yourself: the fully parametric designs are available for Fusion 360 [here](https://a360.co/3ckwvmA). Just change the parameters used and make them any size, number of cassettes, etc. that you need.
This is designed to be pressure fit in a shelf, you can see from the photo above I have cut my 3/8" threaded rods to size and put them together with a connector, which can be expanded to fit into place. I applied some rubber pads to the feet to avoid them slipping about after being fit.
This could use a few adjustments, the feet get a bit in the way of the cassettes on the edge. In my case I just put cassettes that are in non-standard jewel cases at the edges.
fardog publiceert ook op
24 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
