Caster Cup
door Ubertastic
10
Downloads
4
Likes
1
Makes
I designed this for my recliner chair on hardwood floors.
Specification:
- Inner Cup was made for 25mm.
- Outer Base is 39mm.
- 4mm in height.
Notes:
- I used the FIXA stickers from IKEA for the base, but I think there are other ways you could approach it.
- I did not know these were called Caster Cups at the time of designing it.
1/8/2020: Fixed the 1st circle layer issue. Realize it was 1mm above the surface in the design. Discovered it when creating stacking caster cup (remix).
Specification:
- Inner Cup was made for 25mm.
- Outer Base is 39mm.
- 4mm in height.
Notes:
- I used the FIXA stickers from IKEA for the base, but I think there are other ways you could approach it.
- I did not know these were called Caster Cups at the time of designing it.
1/8/2020: Fixed the 1st circle layer issue. Realize it was 1mm above the surface in the design. Discovered it when creating stacking caster cup (remix).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
