Thingiverse
Castle door
por Gophergames
3
Descargas
0
Likes
0
Makes
must use inclusive tolerances in cura or PrusaSlicer
I found the tolerances just worked on my MK3S at .2mm layerhights for the regular door so I also uploaded one where I loosen the tolerances a little bit have not tested
I found the tolerances just worked on my MK3S at .2mm layerhights for the regular door so I also uploaded one where I loosen the tolerances a little bit have not tested
Gophergames también publica en
36 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!