Slicer Discord
Cat Collar Magnet – 3D-Druckmodell von Thingiverse Thingiverse

Cat Collar Magnet

von 66point99
7 Downloads
4 Likes
0 Makes
Zum Modell
Our cat is forever losing his (very much over-priced) collar magnets that trip the latch on his cat-flap.

This thing works as a cheap replacement when a 'standard' fridge magnet (17.5mm diameter + 5mm thick) is inserted + hot-glued.

Note that the magnet slot is deliberately several millimeters taller than the magnet in order to allow for the inevitable intrusion of printed support material.

Thing dimensions: base = 23mm square; height = 22mm.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen