Thingiverse
Cat drinking pond
door JohK
6.9k
Downloads
7.1k
Likes
61
Makes
**UPDATE**: Version 2 of the drinkpond has been out in the wild for quite a while now and I haven't received any complaints whatsoever. If you want to have a drinkpond, you should chose version 2 over version 1.
UPDATE: Version 2 of the drinkpond available now with 5mm higher water level and a cutout to reduce amount of plastic needed and hopefully reduce ABS warping. ATM untested, print at own risk.
This is a cat drinking pond that takes soda bottles (like coke, pepsi, etc) with a pco028 thread as a reservoir. The water level is kept constant without the need for permanent monitoring on your side.
All corners and edges are nicely rounded so your tippy-toe doesn't hurt itself - also it looks much better.
L**** the cat: "Yay, I can haz water *purr*"
Got inspired by the "pond for small animals", my thing is a complete redesign though.
UPDATE: Version 2 of the drinkpond available now with 5mm higher water level and a cutout to reduce amount of plastic needed and hopefully reduce ABS warping. ATM untested, print at own risk.
This is a cat drinking pond that takes soda bottles (like coke, pepsi, etc) with a pco028 thread as a reservoir. The water level is kept constant without the need for permanent monitoring on your side.
All corners and edges are nicely rounded so your tippy-toe doesn't hurt itself - also it looks much better.
L**** the cat: "Yay, I can haz water *purr*"
Got inspired by the "pond for small animals", my thing is a complete redesign though.
JohK publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
