Cat Ears for Headphones
von nannk
2k
Downloads
1.8k
Likes
5
Makes
2 Hairbands with diameter around 40mm are needed.
Attachment system inspired by Kitty Ears for Razer Kraken.
Print:
-0.5mm Layer
-need supports
Probably would suit better an Over-ear Headphones, because of how huge those ears are.
Assembly:
-Attach the adapter to your headphones with Hairband
-Slide the Ear in place.(Also try ro connect those two pieces before asssembly, because the fit might be too tight)
I also painted the inner ear white with acryl paint
16/07/21: Added flat version of Adapter.
Also check those out: https://www.printables.com/model/232352-cat-ears-for-headphones-single-part
Attachment system inspired by Kitty Ears for Razer Kraken.
Print:
-0.5mm Layer
-need supports
Probably would suit better an Over-ear Headphones, because of how huge those ears are.
Assembly:
-Attach the adapter to your headphones with Hairband
-Slide the Ear in place.(Also try ro connect those two pieces before asssembly, because the fit might be too tight)
I also painted the inner ear white with acryl paint
16/07/21: Added flat version of Adapter.
Also check those out: https://www.printables.com/model/232352-cat-ears-for-headphones-single-part
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!