Thingiverse
cat-toy balls
von Lizard_Wizard
28
Downloads
16
Likes
1
Makes
Inspired by user Surveyor - Cat Toy :16402
Was interesting to do in fusion 360.
works well with pla, my heart is broken with soft tpu :D
enjoy..i think humans will enjoy also with cats :)
to brim or not to brim...that's the question! works np on my elegoo neptune 3 no brim. but i would put 3mm brim just for kicks and be safe.
no support.
i would go with a good quality basic .2 or better. the ball will roll better the higher resolution.
obviously you will need to push the inner ball to break from its .8mm stem when printed.
Was interesting to do in fusion 360.
works well with pla, my heart is broken with soft tpu :D
enjoy..i think humans will enjoy also with cats :)
to brim or not to brim...that's the question! works np on my elegoo neptune 3 no brim. but i would put 3mm brim just for kicks and be safe.
no support.
i would go with a good quality basic .2 or better. the ball will roll better the higher resolution.
obviously you will need to push the inner ball to break from its .8mm stem when printed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
