Thingiverse
Catalyst Machineworks - Super Light 3" Camera Mount
door MayDaySr
6
Downloads
6
Likes
0
Makes
(This is Version 1. Check the Version 2 for updates.)
Here are some fixed camera mounts for the Catalyst Machineworks Super Light 3" in 20 deg, 30 deg, and 45 deg variants. The STL and Solidworks SLDPRT files are included with the download. Feel free to modify them as you see fit.
Notes:
1) The camera slot is 11.65mm square. It is a nice fit without squeezing down on the camera too much. For a crash proof setup, take a rubberband, loop it over the camera lens, over the top, back, and bottom of the mount, and loop it back over the lens. It's vibration and crash proof.
You can get a tighter fit with a 11.6mm or 11.55mm slot if you don't like the rubberband.
2) Some props will make contact with the tubes. Slight trimming with a razor will fix that.
Here are some fixed camera mounts for the Catalyst Machineworks Super Light 3" in 20 deg, 30 deg, and 45 deg variants. The STL and Solidworks SLDPRT files are included with the download. Feel free to modify them as you see fit.
Notes:
1) The camera slot is 11.65mm square. It is a nice fit without squeezing down on the camera too much. For a crash proof setup, take a rubberband, loop it over the camera lens, over the top, back, and bottom of the mount, and loop it back over the lens. It's vibration and crash proof.
You can get a tighter fit with a 11.6mm or 11.55mm slot if you don't like the rubberband.
2) Some props will make contact with the tubes. Slight trimming with a razor will fix that.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!