Thingiverse
Catherine wheel
por Onno123
3
Descargas
4
Likes
0
Makes
printed a firework wheel and it was a succes!
i had some difficulties with printing the holders(houders2,3) but it is doable with a brim and supports(or cut the lower part off in slicer).
You need to have at least 4 motors on the side. I don't have a good picture from the final one sadly.
I have two kinds of holders(houder), one for double sided and one for only one side of the wheel.
printed in 4 part tied together with cable wraps.
i had some difficulties with printing the holders(houders2,3) but it is doable with a brim and supports(or cut the lower part off in slicer).
You need to have at least 4 motors on the side. I don't have a good picture from the final one sadly.
I have two kinds of holders(houder), one for double sided and one for only one side of the wheel.
printed in 4 part tied together with cable wraps.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!