Caution Cat Puke (approx. 8" high)

There are various creators that inspired this sign (technically not a remix since it was drawn from scratch), but those creators created one piece signs that were too small to my liking so I pulled up OnShape, Photoshop, 3D builder and created this five piece sign. The sign pieces will only fit on 256mm x 256mm and up beds. This print utilizes the Bambu AMS, but those of you that can figure it out without an AMS feel free to give it a go. Make sure you rotate to see under because the graphics are face down so that you can verify coloration. I have printed this without supports, and with supports. I also recommend a brim but it is not needed as long as your bed is clean and your first layer lays down good. Once printed, check the pin moves freely in both side plates. Put the plates back to back with graphics out, slide pin in. Push end caps on. Enjoy the humor. I will be adding the blanks of these plates soon so you can add your own graphics.