Thingiverse
CC 3" Bulkhead Wrench
von wellingtonbeef
3
Downloads
4
Likes
0
Makes
Bulkhead wrench for a 3" CC Bulkhead, might work on others with the same pattern of tabs on the nut.
You can easily make the handle longer if you would like, I still had trouble at this length because it was REALLY stuck, but my bed wouldn't support much more. You could probably modify it to print in 2 pieces but due to how much pressure you'd be putting on that joint when turning, id advise against it. Hit the handle with a rubber mallet and it loosened right up.
You can easily make the handle longer if you would like, I still had trouble at this length because it was REALLY stuck, but my bed wouldn't support much more. You could probably modify it to print in 2 pieces but due to how much pressure you'd be putting on that joint when turning, id advise against it. Hit the handle with a rubber mallet and it loosened right up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
