Thingiverse
CC Model maker, I3 Mini Octoprint Pi mount
door Lparko
14
Downloads
8
Likes
0
Makes
Designed to hold a raspberry Pi and PiCam to be used for Octoprint on the Cocoon Create Model Maker, Wanhao i3 Mini and similar machines. Fits the Pi 4 and probably earlier Pi's with the same mounting hole dimensions.
The arm for the PiCam is printed in a straight/neutral position and can be slightly heated with a lighter or heatgun and bent to aim the camera in your desired position. PiCam can be attached to the arm with double sided tape.
Depending on your printer supports may be needed for the entire arm or only the very end if you set the support overhang angle to at least 55'.
The arm for the PiCam is printed in a straight/neutral position and can be slightly heated with a lighter or heatgun and bent to aim the camera in your desired position. PiCam can be attached to the arm with double sided tape.
Depending on your printer supports may be needed for the entire arm or only the very end if you set the support overhang angle to at least 55'.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
