Thingiverse
CC2530 & CC2591 Zigbee Router
von max-e-moose
12
Downloads
14
Likes
0
Makes
Inspired by [this thing](https://www.thingiverse.com/thing:4221951) and the creator's invitation to design a better bottom lid, I decided to create a snap-together housing for a Zigbee router using a CC2530 + CC2591 + HLK-PM03 [as described here](https://www.zigbee2mqtt.io/how_tos/how_to_create_a_cc2530_router.html).
This version houses the CC2530 + CC2591 in the lid and the HLK-PM03 in the base and also has plenty of room for wire management/DuPont connectors/LEDs/small trinkets.
Follow the print instructions to create a mesh for the inside of the lid - just behind the zigbee2mqtt logo - to aid with dust prevention. This was glued in place. I also glued the bottom of the HLK-PM03 to the rectangle in the base of the model.
This version houses the CC2530 + CC2591 in the lid and the HLK-PM03 in the base and also has plenty of room for wire management/DuPont connectors/LEDs/small trinkets.
Follow the print instructions to create a mesh for the inside of the lid - just behind the zigbee2mqtt logo - to aid with dust prevention. This was glued in place. I also glued the bottom of the HLK-PM03 to the rectangle in the base of the model.
max-e-moose veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
