Music
Zum Modell
CD rack with display shelf
3
Downloads
23
Likes
1
Makes
A CD rack that can store your CDs, and at the same time show off your favorites ones! It can store 21 CDs, 19 in the rack and 2 at the top.
#### Assembly
3D print all components one time, except for *bridge*, print that one twice. Use the pegs and holes to assemble them, and superglue them together. You can take a look at *components.jpg* to check which file represents which component, although it should speak for itself once you have them all printed out.
#### Print Settings
- Resolution: 0.2mm
- Infill: 10%
- Supports:
- Needed for *back_middle*, *front_middle*, *support*, *top_left* and *top_right*.
- The prints with holes do **not** need supports, these are nearly impossible to remove and the print will be fine without them.
- Rafts: No
Enjoy, leave a comment or share a make if you like!
#### Assembly
3D print all components one time, except for *bridge*, print that one twice. Use the pegs and holes to assemble them, and superglue them together. You can take a look at *components.jpg* to check which file represents which component, although it should speak for itself once you have them all printed out.
#### Print Settings
- Resolution: 0.2mm
- Infill: 10%
- Supports:
- Needed for *back_middle*, *front_middle*, *support*, *top_left* and *top_right*.
- The prints with holes do **not** need supports, these are nearly impossible to remove and the print will be fine without them.
- Rafts: No
Enjoy, leave a comment or share a make if you like!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!