Thingiverse
CD Wall Display
by pjm237
1
Downloads
7
Likes
0
Makes
Inspired by Vinyl displays, I made up a CD display.
It’s a single cradle that creates an overlapping fish scale/ roof shingle orientation of the cases. An individual CD can be removed without disturbing the others in the installation.
An alignment fixture is included.
One of the cradles will need 2 anchors to level the display. All the others should need only 1 anchor. You may find ones on the edges could use 2 anchors.
Note the system does rack to the right. It’s a result of the cases not being square. I did not notice it immediately; there is an optical illusion that hides it. It’s about 2cm per 2 rows.
I recommend supports for the two hooks at the tips.
It’s a single cradle that creates an overlapping fish scale/ roof shingle orientation of the cases. An individual CD can be removed without disturbing the others in the installation.
An alignment fixture is included.
One of the cradles will need 2 anchors to level the display. All the others should need only 1 anchor. You may find ones on the edges could use 2 anchors.
Note the system does rack to the right. It’s a result of the cases not being square. I did not notice it immediately; there is an optical illusion that hides it. It’s about 2cm per 2 rows.
I recommend supports for the two hooks at the tips.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
