Thingiverse
Ceiling Fan Remote Control Holder
door Old-Steve
0
Downloads
3
Likes
0
Makes
I searched for Ceiling Fan Remote on Thingiverse and I did not find a match for this controller so I designed my own wall mount for it. The wall mount that came with it seems like it will break very easy.
This controller measures 50mm’s wide at the top, 44mm’s wide at the bottom. It is 18mm’s tall (thick) and it measures 133mm’s long across the bottom.
I added my own supports for the 2 overhangs. Trim away post print.
Printed in ABS .2 layer 25% infill Printing a little slow at 28mm’s per sec
This controller measures 50mm’s wide at the top, 44mm’s wide at the bottom. It is 18mm’s tall (thick) and it measures 133mm’s long across the bottom.
I added my own supports for the 2 overhangs. Trim away post print.
Printed in ABS .2 layer 25% infill Printing a little slow at 28mm’s per sec
Old-Steve publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
